How to Cut a Tree Down With a Chainsaw

how to cut tree down with chainsaw

There are several ways to safely cut a tree with a chainsaw. Safety equipment is critical and should be worn by everyone involved in the process. There are also two ways to escape from the tree – Plunge and Safety equipment. Read on to learn the steps to safely fell a tree with a chainsaw. This article will cover both methods. Using safety equipment to cut down a tree is a safe and effective way to get the job done.

Safety equipment

The most important piece of safety equipment to wear when cutting down a tree with a chainsaw is a safety helmet. A chainsaw produces high amounts of noise, and prolonged exposure to this noise can result in permanent hearing damage. If you’re going to cut a tree with a chainsaw, you should also wear earplugs or protective head gear. Earplugs, a pair of which can be found at most hardware stores, will reduce the noise from a chainsaw by 20 decibels. However, be sure to research local environmental regulations and check for any permit requirements. Not following codes could lead to hefty fines.

Proper felling technique

Use proper felling techniques when cutting down trees. Besides avoiding injuries, you should be aware of the dangers associated with falling trees. The following are some of the things to keep in mind before you start felling a tree. Before you begin, make sure that the area where the tree is growing is clear of brush. Dead branches and other debris can tangle in your clothes, preventing you from getting out safely once the tree falls.

Planning two escape paths

Before cutting a tree down with a chainsaw, it’s a good idea to plan two escape routes. Plan one path that is parallel to the tree’s back, and another that is 45 degrees away from the cut. Make sure your chainsaw is charged and sharp, and that you’re wearing a safety helmet and ear-defenders. Wear heavy-duty gloves and heavy boots, and wear chainsaw-proof clothing.

Plunge felling

To safely cut a tree down, it is necessary to understand the proper way to plunge fell it. First, cut a notch in the tree about one-fifth of its diameter. If the tree is leaning, cut the notch to a depth of approximately knee height. The notch should be shallow enough to allow for felling wedges. You should then remove the saw and walk away from the tree, keeping a 45-degree angle.

Safety signs

Before you begin felling a tree, you should always clear the area and erect safety signs. The reason is simple – trees are often near power lines, and touching them can send your lights out. If you don’t want to endanger anyone, call the power company to get them to cut the tree for you. If you can’t get a hold of the power company, you should call local authorities to have the tree removed safely. Also, you should check the tree’s “fall radius” to make sure it doesn’t fall on anyone.